leave your comments
Helical Gear Manufacturer(2014-03-10)

Helical Gear is a very regular Gear. Helical Gears are required to be cut at a particular angle to the face of the Gear. Two touching Helical Gears need to have equal helix angle but contrasting hand. This helps them to run smoothly and fluently and also prevents noise pollution. They can also be used to mesh two shafts which are not parallel with each other and between two perpendicular shafts.
Helical Gears generally have longer and stronger teeth than the other classes of Gears. Due to the greater surface contact area on the teeth these Gears are capable of carrying heavy load but the efficiency is reduced because of the same reason.APMC produce Helical Gears that are quiet and make less vibration. There is an intriguing thing about Helical Gears that is if the angles of the Gear teeth are correct, they can be raised on perpendicular shafts, wherein the revolving angle is adjusted by 90 degree. These Gears are very similar to Spur Gears except that the teeth of Helical Gears are cut at an angle to the axis. These are available in both right and left hand configurations.
The Helical Gears offered by us are made as per the standards of the industry widely used in wind and engineering industries.These can also be customized as per the client’s requirements. We provide Helical Gears upto 3200mm OD and 40 module in different varieties such as hard, soft or ground. Helical Gears are quite alike Industrial Gears. They have teeth that are slanted and thus help in meshing the Gear. The teeth of Helical Gears are connected better than those of Spur Gear.
They can be configured to either crossed or parallel as per the needs of the applications. When it comes to mechanics,parallel Helical Gears are much better. The reason behind this is that helices meet at tangents which does not happen in crossed gears thus limiting the contact point to the surface of the tooth. So it is not advisable for applications that concern heavy loads to use crossed gears.
We offer both single as well as multi segmented Helical Gears. The materials used are MS or Alloy Steel, Carbon Steel as per ADTM, BS, IS, AISI, SAE or any as per customer requirements. The manufacturing capacity is 300 mm to 3200 mm OD. Its available up to 40 modules.
Since our Helical Gears are extremely durable and does not produce noise even in high speed. They are extensively used in wind poweri, blowers, feeders, rubber and plastic industry, rolling mills, food industry, conveyors, oil industry, elevators and other heavy industries. We also serve marine, defence, food processing, grinding mills, paper, surface mining, fertilizer industries and many others.